5/28/2023 0 Comments Jdm car stickers![]() ![]() It is not advised to fit stickers to poorly prepped paint. Using a heat gun or hairdryer can make removing stickers easier if they have been on for some time. If removed properly they should leave little to no residue behind. Make sure you are happy with the position before fitting. ![]() Stickers are not reusable once stuck they can’t be repositioned. Large stickers and Sunstrips are easier to fit with two people, so grab a friend (One that won’t stick it wonky though!). Heating the decal again just before removing the transfer film can greatly improve adhesion and will allow the transfer film to peel away cleanly. ![]() Alternatively, you can provide a small amount of heat to the surface beforehand with a heat gun or hairdryer (Do not over-heat the area). If fitting stickers in lower temperatures, try to do so in direct sunlight. ![]() Fitting stickers in the cold or onto cold surfaces is not recommended (below 10☌) Temperature is also important for fitting decals. Spend extra time cleaning and drying the glass before fitting. Glass surfaces are even harder to clean thoroughly. This includes textured/wallpapered walls, surfaces that contain rust, damaged lacquer or any other paint damage, stickers will also not stick to certain textured/bare plastics commonly used in vehicle interiors or ‘bare’ bumper trims.Ĭleaning and drying the surface is the MOST IMPORTANT part of fitting any sticker. Please note our stickers are not suitable for any textured surfaces. We recommend waiting at least 30 days before fitting any stickers to allow the paint to fully cure and off-gas. Please do not fit our stickers on freshly painted surfaces. windows, cars, bikes, smooth walls, toolboxes, ect. Our stickers will stick to any smooth painted surface or any glass that is thoroughly cleaned and free from dust, dirt, grime, and grease. Our online fitting guide contains information on how to apply stickers correctly. Most of our stickers come with a clear transfer film for easy fitting in one go as opposed to sticking on separate pieces individually (I mean, how annoying would that be right?) Sometimes this is referred to as ‘flipping the sticker’, or a ‘mirrored cut’. Reverse cut means the sticker is cut in reverse so that it can be fitted on the inside of a window or glass and can be viewed from the outside and will read correctly. Please contact us if you need a specific measurement that the sticker must fit within and we can adjust the stickers to suit.Īll of our stickers by default are standard cut for external application, for gloss colours we can offer an reverse cut sticker by request, please contact us if this is something you would like – please note this option is only available for gloss colours, all other colours can’t be reverse cut. Sizing of our stickers is typically mentioned on the description tab of each item, or is shown as a selectable option. We cannot guarantee that the colour you see accurately portrays the true colour of the product. We try to edit our photos to show the samples as life-like as possible, but please understand the actual colour may vary slightly from your display. This is because every device has a different capability to display colours and everyone sees these colours differently. Please note that actual colours may vary. Whatever colour(s) you choose will be the only part that remains once fitted. The stickers are die-cut so have no backgrounds. Our stickers do not rapidly fade or discolour like some low quality stickers can. Matt colours are rated for 4-5 years of use.Īll other special effect colours are rated for 3+ years of use. Gloss colours are rated for 5+ years of use. All colours can be applied both indoors and outdoors. Made in the UK with high-quality in-house designed vector artwork, cut on premium-grade vinyl film. ![]()
0 Comments
Leave a Reply. |